Filter
Top Products
24
Troubleshooting, Adjustments, & Service
SEAT ADJUSTMENT
The seat and ground speed control levers should be
adjusted so that operator’s elbows are supported by the
arm rests when his/her hands are on the controls, and
the ground speed control levers can be moved through
their full range of motion without contacting the
operator’s legs.
Seat Position Adjustment
The seat can be adjusted forward and back. Move the
adjustment lever (A, Figure 20) towards the left hand
side of the machine, slide the seat to the desired
position, and release the lever.
Figure 20. Seat Adjustment
A. Adjustment Lever
Figure 21. Control Lever Adjustment
A. Alignment Hardware
B. Placement Hardware
C. Ground Speed Control Lever
B
C
A
A
GROUND SPEED CONTROL LEVER
ADJUSTMENT
The control levers can be adjusted in three ways.The
alignment of the control levers, the placement of the
levers (how close the ends are to one another) and the
height of the levers can be adjusted.
To Adjust the Handle Alignment: Loosen the mount
bolts (A, Figure 21) and pivot the lever(s) (C) to align with
each other.
To Adjust the Handle Placement: Loosen the jam nuts
and adjust the placement bolt (B, Figure 21) in or out to
properly adjust the lever end spacing.
To Adjust the Handle Height: Remove the mounting
hardware and reposition the handle either up or down
from its original position. You will need to readjust the
handle alignment as described above.