Filter
Top Products
14
Section 3 - MAINTENANCE
3.3.4. TRACTOR LUBRICATION
(Continued From Previous Page)
3. Clutch/Brake Pivot
The clutch/brake pivot is located on the L.H.
underside of the tractor and is lubricated with one
shot of general purpose grease. See Figure 3.6.
FIGURE 3.6
4. Steering Sector Gear
Lubricate with a light coat of general purpose grease.
See Figure 3.7.
FIGURE 3.7
5. Steering Shaft
Lubricate steering shaft wear points with a light coat
of 30 wt. Motor oil.
6. Steering Drag Link
Lubricate both ends of steering drag link with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.8.
FIGURE 3.8
7. Steering Tie Rod
Lubricate both ends of steering tie rod with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.9.
FIGURE 3.9
8. Park Brake Lever
Using 30 wt. motor oil, lubricate the park brake lever
mechanism pivot points, which are located on the left
hand underside of tractor. See Figure 3.10. Lubricate
mechanism with a thin coat of 30 wt. motor oil.
FIGURE 3.10
9. Deck Lift Mechanism
Lubricate all wear and pivot points of the deck lift.
CLUTCH/BRAKE
PIVOT LUBRICATION
FITTING
LUBRICATE
BOTH ENDS
OF TIE ROD
LUBRICATE
COMPONENTS ON
UNDERSIDE OF
TRACTOR
PARK BRAKE
LEVER
DRAG LINK
LUBRICATION
POINT
LUBRICATE
STEERING
SHAFT GEAR
LUBRICATE
STEERING
SECTOR GEAR