Filter
Top Products
5
SETUP INSTRUCTIONS
The majority of the assembly has been completed at the factory. After removing the machine from the shipping container
you will be required to unfold the handles, attach the debris bag, and insert the accessory plug into the vacuum nozzle.
Initial adjustments and operational tests were performed prior to shipping the machine. Due to the effects of shipping,
handling and storage, the machine must be carefully inspected for loose, damaged parts and any necessary final
adjustments completed at the time of setup. It is very important that you register your purchase to insure warranty
coverage. Please fill out your product registration form and mail it to the address listed on the form.
1. Carefully remove the contents from the shipping
container. You can avoid having to lift the machine
by cutting the rear out of the box. The machine can
then be rolled out.
2. Unfold the handles being careful not to kink the
control cables and place in the operating position.
Tighten the hardware securely.
3. Attach the bag adapter to the discharge opening.
Open the discharge door and slide the adapter down
over the two flanges at the opening. Make sure the
adapter is secured in place on both sides. Close
door. See Figures 1 and 2.
4. Attach two rear straps located near the top of the
debris bag to the handles. See Figure 3.
5. Install accessory plug. Line up the two lugs on the
plug with the two notches in the vacuum nozzle.
Insert nozzle and rotate 90 degrees to lock in place.
See Figure 4.
6. Fill engine crankcase with oil to proper level. Refer
to engine owner’s manual for specifications.
7. Move machine to open area where fumes can safely
dissipate and away from all sources of ignition. Fill
fuel tank. Refer to engine owner’s manual for
specifications. Do not over fill.
8. Setup is complete. Please proceed to the Pre-Start
Check List. Follow and complete each step carefully.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
DISCHARGE
DOOR
BAG
ADAPTER
MOUNTING
FLANGE
ATTACH STRAPS
TO HANDLES
INSERT ACCESSORY
PLUG INTO NOZZLE