Filter
Top Products
17
SECTION 3 - OPERATING INSTRUCTIONS
3.11 ADJUSTING BLADE ON CUTTER
SPINDLE (Continued)
FIGURE 3.13
3.12 ADJUSTING FIXED DECK ATTACHMENT
The mower deck has four different positions for attaching
it to the power unit. The lowest setting provides a cutting
height range of 1-1/2” to 2-1/2”, the middle low cut is 2-
1/4” to 3-1/4”, the middle high cut is 3” to 4”, and highest
cut is 3-3/4” to 4-3/4”. Make sure the spacers on the
caster wheels are moved up or down as shown to
correspond with the bolt positions to keep deck level.
Once a desired cutting height is reached, attach the
mower deck to the power unit by installing 3 bolts on
each side in selected height of cut holes. Tighten bolts to
70 to 80 foot pounds torque. See Figures 3.14 A-D.
FIGURES 3.14A-B
FIGURES 3.14C-D
CUTTER
HOUSING
PULLEY
SPACERS
ON TOP
CUTTER
HOUSING
BLADE
SPACERS ON
BOTTOM
SIDE PROFILE OF UNIT
SPACERS
DECK
POWER
UNIT
BLACK DOTS
REPRESENT
BOLT ANCHOR
HOLES
REAR
WHEEL
CASTER
WHEEL
FIGURE 3.14A: LOW CUT 1-1/2” TO 2-1/2”
FIGURE 3.14B: MIDDLE LOW CUT 2-1/4” TO 3-1/4”
SPACER
SPACERS
FIGURE 3.14C: MIDDLE HIGH CUT 3” TO 4”
SPACERS
FIGURE 3.14D: HIGH CUT 3-3/4” TO 4-3/4”