Filter
Top Products
SECTION 5 - ADJUSTMENTS
5.3 HANDLE HEIGHT
The operator handle can be adjusted for operator
comfort as follows:
1. Loosen the upper carriage bolt and nut on both sides
of handlebar. See Figure 5.4.
2. Remove lower carriage bolt and nut on both sides of
handlebar.
3. Raise or lower handlebar to desired height. See
Figure 5.3.
4. Install the carriage bolt and nut in the lower hole in
handlebar and securely tighten nut. See Figure 5.4.
5. Securely tighten the upper carriage bolt and nut.
6. After adjusting the handle height readjust traction
links as described earlier. Shift rod (Connects the
ground speed control lever and the transmission) will
have to be readjusted.
7. Readjust traction levers/rods when handle height is
changed.
5.4
1.
2,
3.
TRANSMISSION SHIFT LEVER
ADJUSTMENT
Disconnect the hair pin from shift rod that connects
to the Transmission Shift lever. See Figure 5.5.
Move the Transmission Shift Lever to the neutral
position. Move the shift lever, located on the
transmission, to the neutral position.
Rotate the shift rod clockwise or counter clockwise to
allow the upper portion of shift rod to be inserted into
the ground speed control lever without moving the
speed control lever or the Transmission Shift lever.
Reinstall hair pin. See Figure 5.6.
TRANSMISSION
SHIFT
LEVER
(3)%-
(1)--,_.l
*FACTORY SETTING U
't,
DISCONNECT
SHIFT ROD
FROM THIS
POINT
SHIFT ROD
FIGURE 5.3
FIGURE 5.5
LOOSEN
UPPER
CARRIAGE
BOLT
REMOVE
LOWER
CARRIAGE
BOLT
RAISE
LOWER
SHIFT
SHIFT
FIGURE 5.4
20
FIGURE 5.6