Filter
Top Products
SECTION 4 - SERVICE & LUBRICATION INFORMATION
HOURS PROCEDURE COMMENTS
BREAK-IN Check all fasteners for proper tightness
Change Engine Oil and Filter at 5 hours ..............................See engine manual
Change Hydraulic Oil and Filter at 25 hours ........................Use SAE 10W-30.
Reservoir capacity 1 Gal.
8 HOURS Check/Change Engine Oil ...................................................Change oil if extreme dusty conditions
(Daily) Clean Air Filter......................................................................More often if needed
Clean Blower screen ............................................................More often if needed
Remove Debris from under Belt Cover ................................More often if needed
Sharpen Cutter Blades .........................................................Tighten Cap Screw to 70 - 80 ft. lbs.
Grease Cutter Spindle Bearings...........................................Use Chevron SRI Grease (NLGI2).
Check Hydraulic Reservoir...................................................Add oil if needed
40 HOURS Check Tire Pressure.............................................................Add or adjust as Required
(Weekly) Check Safety Interlock System.............................................Inspect Switches for ease of Operation
Grease Traction Control Levers ...........................................General Purpose Grease
Inspect Traction Lock for Wear.............................................Replace if Worn
Change Engine Oil................................................................More often if needed
Replace Air Filter ..................................................................More often if needed
Grease Caster Wheel Bearings............................................General Purpose Grease
Grease Caster Wheel Pivot..................................................General Purpose Grease
Grease Idler Arm Pivots........................................................General Purpose Grease
200 HOURS Fuel Filter..............................................................................Replace with Snapper P/N 1-4359
(Monthly) Check all Fasteners for Proper tightness .............................See Torque Specifications
Change Engine Oil Filter ......................................................See Engine Manual
Clean and Adjust Spark Plugs..............................................See Engine Manual
Check Belt Tension...............................................................See Operator’s Manual
Lube Controls and Linkages.................................................Use Medium Duty Oil
Change Hydraulic Oil and Filter............................................Use SAE 10W-30 Oil.
Reservoir capacity 1 Gal.
GREASE ZERK LOCATION
GREASE
DAILY
GREASE
WEEKLY
1 on the Hydro Pump Belt Idler Arm Pivot
X
1 on each Spindle Housing (Total of 2 on 36” Deck & 3 on 48”, 52”, 48”, & 61” Decks)
X
1 on each Idler Arm Pivot (Total of 1 on 36” Deck & 2 on 48”, 52”, 48”, & 61” Decks)
X
1 on each Caster Support Arm (Total of 2)
X
1 on each Caster Wheel (Total of 2)
X
1 on each Traction Control Lever (Total of 2)
X
MAINTENANCE/REPLACEMENT PARTS
MAINTENANCE PARTS
36” Cutter Blade (Requires Two Blades) 2-9246
48” Cutter Blade (Requires Three Blades) 2-9247
52” Cutter Blade (Requires Three Blades) 2-9246
61” Cutter Blade (Requires Three Blades) 2-9251
36” Deck Engine to Cutting Deck Belt 2-9255
48” Deck Engine to Cutting Deck Belt 2-9262
48” Deck Spindle to Spindle Belt 2-9261
52” Deck Engine to Cutting Deck Belt 2-9267
52” Deck Spindle to Spindle Belt 2-9266
61” Deck Engine to Cutting Deck Belt 2-9269
61” Deck Spindle to Spindle Belt 2-9268
Parts Manual for Pro Hydro Series 1 06926
20