Filter
Top Products
24
Troubleshooting
Troubleshooting
WARNING
Before performing any adjustment or service to
snowthrower, stop the engine and wait for
moving parts to stop. Remove the key. To
prevent accidental starting, disconnect the
spark plug wire and fasten away from the plug.
PROBLEM POSSIBLE CAUSE REMEDY
Engine fails to start. 1. Key is OFF. 1. Push key in to the ON position.
2. Failure to prime cold engine 2. Press primer button twice and
restart.
3. Out of fuel 3. Fill fuel tank.
4. Choke OFF - cold engine. 4. Turn choke to ON.
5. Engine flooded. 5. Turn choke to OFF; try starting.
6. No spark. 6. Check gap. Gap plug, clean
electrode, or replace plug as
necessary.
7. Water in fuel, or old fuel. 7. Drain tank (Dispose of fuel at an
authorized hazardous waste
facility). Fill with fresh fuel.
Engine starts hard or runs poorly. 1. Fuel mixture too rich. 1. Move choke to OFF position.
2. Carburetor adjusted incorrectly. 2. See your dealer for adjustments.
3. Spark plug faulty, fouled, or
gapped improperly.
3. Clean and gap, or replace.
4. Fuel cap vent is blocked. 4. Clear vent.
Scraper bar does not clean hard
surface.
1. Skid shoes improperly adjusted. 1. RAISE skid shoes (this lowers the
scraper bar).
1. Skid shoes improperly adjusted. 1. LOWER skid shoes (this raises
the scraper bar.)
Auger does not rotate. 1. Auger control not engaged. 1. Engage auger control.
2. Foreign matter blocking auger. 2. STOP engine and REMOVE the
key. DISCONNECT the spark plug
wire. Clear auger using clean-out
tool. See warning in SAFETY
RULES.
3. Auger drive clutch cable slack. 3. Tighten to remove slack. See
auger clutch cable adjustment.
4. Auger drive belt slipping. 4. Check auger drive belt
adjustment.
5. Broken belt. 5. Replace belt.
6. Shear pin broken. 6. Replace shear pin.
TROUBLESHOOTING
This section provides troubleshooting and service
instructions. Locate the problem and check the
possible cause/remedy in the order listed.
Also, refer to the engine manufacturer’s Owner’s
Manual for additional information.
For problems not covered here, contact your local
dealer.