Filter
Top Products
3 unit assembly
Note: Please refer to Parts List for correct part identification and placement.
FRONT WHEEL ASSEMBL
Y
• Attach left and right caster brackets to caster wheel
using 3/8-18 x 2-1/4 bolt and lock nut. Insert bolt through
hole in bracket. Place caster wheel onto bolt. Place
other caster bracket onto bolt. Secure with lock nut. Do
not over tighten. Wheel must rotate freely.
• Align caster brackets with the threaded holes located
near the discharge on the front of the machine. Note:
Angled edge of mounting brackets should be down-
wards, with holes toward top. Fasten with two 5/16-
18 x 3/4” hex bolts. Do not tighten. (Note: Fit each bolt
with one 5/16 split lock washer and one 5/16 flat wash-
er before installing.)
• Check caster wheel for proper vertical alignment (cam-
ber), adjust as necessary, then tighten bolts.
SIDE AIR DEFLECTOR
• Attach side air deflector to top of discharge chute by
aligning holes in deflector with threaded holes in top of
chute snout. Fasten with two 5/16-18 x 3/4” hex bolts.
(Note: Fit each bolt with one 5/16 split lock washer and
one 5/16 flat washer before installing.)
Note: Deflector should be angled downward.
HANDLE ASSEMBLY
• The upper handles are shipped in the folded storage
position. To unfold, loosen two handle knobs and rotate
up to the operating position. The upper handles are
secured with four knobs. Insert two 5/16-18 x 2 curved
head bolts through the handles directly below the two
shipping knobs. Place one internal tooth lock washer on
each of the bolts. Thread knobs onto curved head bolts.
Tighten all four knobs securely.
Assembly complete. Your unit is now ready to be started and checked for proper operation.
Some minor final adjustments may be required; see the Maintenance portion of this manual.
5