Filter
Top Products
-- 4 --
Small
Opening
Zipper
Opening
Elbow
T ube
Rib
NOTE:
Makesureedgeofthesmallopening
is flush against the flared area of the elbow
tube, and the rib on the elbow tube is on the
bottom.
3. Closethezipperonthebag.Makesurethe
zipper is closed completely.
4. Remove blower tubefrom engine.
Rib
Groove
5. Inserttheelbowtubeintothebloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwisetosecureelbowtube.
VACUUM TUBE ASSEMBLY
W ARNING:
Stop engineand besure
the impeller blades havestopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotatingblades can cause
serious injury.
1. Align the lower vacuum tube as shown.
Push lower vacuum tubeinto uppervacu-
um tube.
Lower Vacuum Tube
Upper Vacuum
T ube
2. Insert thetipofascrewdriverinto thelatch
area of the vacuum inlet.
Latch Area
Blower
Outlet
Vacuum
Inlet Cover
Latch
Area
3. Gently tilt thehandleofthescrewdriverto-
ward the back of the unit to release the
latch while pulling up on the vacuum inlet
cover with your otherhand.
4. Holdthe vacuuminlet cover openuntilup-
per vacuum tube is installed.
Vacuum Inlet
Vacuum
Inlet
Cover
Retaining Post
5. Placethehooksof theuppervacuumtube
on the retaining posts of the unit.
6. Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch.
Retaining
Post
Hook
Inlet Cover
Latch
PIVOT
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of ascrewdriver into the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver toward
the back of the unit to release the latch
whilepullingupontheuppervacuumtube
with your other hand.
Latch Area
3. Remove the vacuum bag.
4. Close the vacuum inlet cover and make
sure it is latched closed.
5. Reinstall the blower tube (see BLOWER
TUBE ASSEMBLY) .
For Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com