Filter
Top Products
S150X 21HP, 23HP, 25HP & 27HP - 48” & 52” Mower Deck
10/2007 5
TP 300-7343-A-M1-SP
Roll Bar Assembly
Install the Roll Bar
1. Unpack the roll bar and hardware from the box.
2. Remove the clevis pin (C, Figure 6) from the lanyard
(A).
3. Install the lanyard anchor (B) onto the lanyard as
shown in Figure 6.
4. Reinstall the clevis pin on the lanyard.
Figure 8. Upright Tube Placement (Left Side Shown)
A. Upright Tube
B. 1/2-13 X 3” Bolt
C. 1/2” SAE Washer
D. Rear Bumper
E. Frame of the Machine
F. 1/2-13 Nylock Flange Nut
Figure 7. Assemble the Top Loop
A. Top Loop Tube
B. Plastic Cap
C. Rubber Stop
A
B
C
Figure 6. Assemble the Retainer Pins
A. Lanyard
B. Lanyard Anchor
C. Clevis Pin
A
B
C
Assemble the Top Loop
1. Install the plastic cap (B, Figure 7) into the end of the
top loop tube (A). Repeat for other end of tube.
2. Install the rubber stop (C) against the inside of the
pivot mount. Repeat for other end of tube. See
Figure 7.
Install the Upright Tubes
1. Remove the bolts and nuts on one side of the
machine that secure the rear bumper for shipping.
Save this hardware for reinstallation in Step 3.
2. Place the roll bar upright tube onto the outside of the
rear bumper (A, Figure 8). Refer to Figure 9 for the
correct roll bar orientation.
3. Refer to the insert in Figure 8. Loosely install a bolt
with a flat washer through the both holes of the
upright tube, rear bumper, and the frame from the
outside of the machine. Loosely install a nylock
flange nut on the bolt.
4. Repeat process for the other side of the machine.
A
B
C
D
E
F
A