Filter
Top Products
17
Operating the Tractor
Adjusting Mower Cutting Height
The cutting height is infinitely adjustable between
approximately 1” and 3-5/8” (2,5-9,2 cm).
Electric Height of Cut Models: The cutting height
adjustment switch (D, Figure 5) controls the mower cut-
ting height. This same switch also controls the spout
rotator motor when a snowthrower is installed. The
arrows on the switch correspond to the direction of
adjustment (UP arrow raises cutting height, RIGHT arrow
rotates the spout right, etc). When the adjustment indi-
cator has reached the end of its travel, release the
switch; holding the switch down will damage the motor
Manual Lift Models: The cutting height adjustment knob
(B, Figure 5) controls the mower cutting height. Turn the
knob clockwise to raise the deck and counterclockwise to
lower it.
Figure 5. Raising and Lowering Mower
A. Attachment Lift - Manual
B. Cutting Height Control Knob
C. Attachment Lift - Hydraulic
D. Electric Height of Cut Switch
A
C
B
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age. • Do not use another vehicle to push or
pull this unit. • Do not actuate the transmis-
sion release valve lever while the engine is
running.
Figure 4. Transmission Release Lever & Fuel Tank
A. Fuel Tank Cap
B. Transmission Release Lever
B
A
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release (B, Figure 4) back
approximately 2-1/2” (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
D
Not for
Reproduction