Filter
Top Products
Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
SLOT IN END
OF DRIVE DISC
BOLT
PULLEY POSITION
4.4.1. Engine Drive Belt Replacement
(Stretch Type Belts) DECKBRACKET
(Continued From Previous Page)
IMPORTANT: Drain fuel tank before tipping mower. (PARTIALLY SHOWN) k.,J'_
DO NOT tip machine with carburetor or spark plug down.
Oil from crankcase will saturate the air filter and cause the "_
engine to be hard to start or not start at all. If (_
contamination does occur, the air filter will have to be
replaced.
BOLT RETAINER
_'_ INTERNAL TOOTH
) e,----'--" LOCKWASHER
NUT
3. Remove the driven disc. Refer to Section
"Replacing Driven Disc Rubber Ring" for driven disc
removal procedure.
4. Drain fuel tank before tipping mower. Do not tilt
mower with spark plug or carburetor down. Tilt
mower up on its rear wheels and remove blade and
blade hub. Assistance from another person may be
necessary to hold mower in the tilted position.
5. Hold the slotted end of the drive disc bolt with a
screwdriver and remove the nut and internal tooth
lock washer. See Figure 4.16.
6. Remove the belt cover located under deck.
7. Lift the drive disc up and remove worn belt.
8. Loop one end of new belt over engine pulley and
insert the other end through slot in deck. Refer to
Figure 4.15.
9. Loop the belt around the pulley on the bottom of
the drive disc.
10. Reinstall drive disc and retaining hardware.
IMPORTANT: 1) The square shoulder of the drive
disc bolt must fit into the square hole of the bushing.
2) The square end of bushing must fit into the
bracket slot.
11. Reinstall belt cover and tighten bolts securely.
12. Reinstall blade hub and cutter blade.
Recommended torque for blade cap screw is 40 ft. Ibs.
FIGURE 4.16
4.4.2. Transmission Poly-V Belt Replacement
1. Remove the driven disc. Refer to Section on
"Replacing Driven Disc Rubber Ring" for procedure.
2. Note the routing of the old belt around the three
pulleys before removing it. See Figure 4.17.
3. Place new Poly-V Belt over end of hex shaft and
onto drive pulley.
4. Work belt onto top of idler pulley.
5. Twist belt sideways and pull it upward between
the differential bracket and driven pulley and then
down into the pulley groove. Make sure the Poly-V
Belt is above belt guide. See Figure 4.17.
DRIVE
PULLEY
HEX SHAFT -
IDLER
BELT GUIDE
BRACKET
PULLEY
f
ROUTING OF POLY-V BELT
FIGURE 4.17
20