Filter
Top Products
21
Troubleshooting
PROBLEM POSSIBLE CAUSE REMEDY
Auger rotates, but snow is not
thrown far enough
1. Chute deflector too low.
2. Engine speed too slow.
3. Ground speed too fast.
4. Snowthrower discharge chute clogged.
5. Auger belt loose or worn.
1. Adjust deflector as necessary.
2. Set speed to full throttle.
3. Use slower speed selector setting.
4. STOP engine and REMOVE the key.
DISCONNECT the spark plug wire.
Clear auger using clean-out tool. See
warning in SAFETY RULES.
5. Check auger drive belt adjustment
Scraper bar does not clean hard
surface.
1. Scraper bar height improperly
adjusted.
1. RAISE skid shoes
LOWER scraper bar (later models)
Auger does not stop when auger
lever is released
1. Auger clutch cable too tight or bent.
2. Auger drive belt out of adjustment.
3. Auger belt guide out of adjustment.
4. Free hand control not releasing.
1. Loosen or straighten clutch cable.
2. Adjust auger belt.
3. Adjust auger belt guide.
4. Lubricate free hand linkage.
Scraper bar picks up and throws
stones on gravel drive.
1. Scraper bar height improperly
adjusted.
1. LOWER skid shoes
RAISE scraper bar (later models)
Poor traction
1. Tires slipping. 1. Check tire pressure and tread.
Snowthrower does not stop when
drive lever is released
1. Traction drive clutch cable bent or too
tight.
1. Loosen cable to remove slack or
replace. See adjustment procedure.
Snowthrower does not drive when
drive lever is engaged.
1. Traction drive clutch cable loose.
2. Drive belt loose, broken, or stretched.
3. Drive roller chain damaged.
4. Traction lock pins in free-wheeling
position (OUTER hole).
5. Friction disc worn.
1. Tighten to remove slack. See adjust-
ment procedure.
2. Replace drive belt.
3. Replace chain.
4. Change traction lock pins to INNER
hole to engage traction drive.
5. Replace disc (see your dealer).
Discharge control is difficult to
operate.
1. Gearing needs lubrication
2. Worm gear not adjusted properly.
3. Control rod gears misaligned.
4. Pin connecting control shaft broken.
1. Oil or grease as required.
2. Adjust worm gear. See adjustment
procedure.
3. Adjust gear bracket. See adjustment
procedure.
4. Replace pin.
Snowthrower veers to one side.
1. Tire pressure not equal.
2. One wheel is set in free-wheeling
mode. (Traction lock pin is in the
OUTER hole).
1. Check tire pressure.
2. Make certain BOTH traction lock pins
are in the INNER holes (to engage
traction drive).
Excessive vibration.
1. Loose parts or damaged auger. 1. STOP engine and REMOVE the key.
DISCONNECT the spark plug wire.
Tighten all hardware. Replace auger
if necessary. If vibration continues,
see your dealer.
Drive fails to move snowthrower
at slow speeds.
1. Traction drive out of adjustment. 1. Readjust drive, or shift speed selector
setting up one speed faster.