Filter
Top Products
13
Section 3 – MAINTENANCE
3.1 INTRODUCTION
To retain the quality of the Tractor, use genuine
SNAPPER replacement parts only. Contact a local
SNAPPER dealer for parts and service assistance. For
the correct part or information for a particular Tractor,
always mention the model and serial number.
SNAPPER recommends returning the Tractor to an
authorized SNAPPER dealer annually for inspection
and addition of any new devices, which might upgrade
the safety of the Tractor. For the nearest SNAPPER
dealer in your area, check the yellow pages under the
heading LAWN MOWERS. For engine parts and
service, look for the engine manufacturer’s dealers
under the heading, ENGINES - gasoline.
3.2 SERVICE - AFTER FIRST 5 HOURS
WARNING
DO NOT attempt any adjustments, maintenance or service
with the engine or blades running. STOP blades. STOP
engine. Set brake. Remove key. Remove spark plug wire
from spark plug and secure wire away from spark plug.
Engine and components can be extremely hot. Avoid burns
by allowing engine and components sufficient time to cool.
3.2.1. CHANGE ENGINE OIL
The engine is equipped with a Fastex™ oil drain.
1. Rotate drain body counterclockwise and pull out to
open drain. See Figure 3.1.
2. Drain oil into a 2 quart container placed beneath end
of oil drain.
3. After all oil has drained, push drain body "IN" and
rotate clockwise to close.
4. Fill engine with new motor oil as specified in engine
owner's manual.
WARNING
The following procedure requires the engine and blades
to be operated. Exercise extreme caution. Clear area of
loose parts & tools first. Only operate blades when seated
in the operator’s seat.
3.2.2. CHECK BLADE BRAKE
1. Check blade brake for proper function. Blades should
stop rotating in 5 seconds or less after pushing the blade
switch “IN” to the OFF disengaged position.
2. If blades continue to rotate longer than 5 seconds do
not operate machine. Contact your SNAPPER dealer for
assistance.
3.2.3. CHECK MOWER BLADES
1. Remove deck from tractor.
2. Carefully position deck to access blade.
3. Check blade for sharpness, wear and damage.
Refer to Section “BLADE WEAR LIMITS”.
4. Check blade for straightness. Refer to Section
“ADJUSTING MOWER BLADE”.
5. Check torque of blade mounting bolts. Torque to:
42" deck - 30 to 40 ft lbs. See Figure 3.2.
48" deck - 70 to 80 ft lbs.
FIGURE 3.1
FIGURE 3.2
WARNING
Blades must stop rotating in 5 seconds or less after
blades have been turned off. DO NOT operate machine
until blade brake has been repaired and functioning
properly. Contact your SNAPPER dealer for assistance.
TORQUE TO
30 TO 40 FT.LBS.
42” DECK
SHOWN
OIL
FILLER
TUBE
ROTATE COUNTER-
CLOCKWISE AND PULL
OUT TO OPEN.
PUSH IN AND ROTATE
CLOCKWISE TO CLOSE.
FASTEX™
OIL DRAIN