Snapper LT160H42GBV, LT160H42GBV2, LT180H48GBV2 Lawn Mower User Manual


 
15
Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section
“SERVICE - EVERY 25 OPERATING HOURS”. Also
see Service Schedule.
3.4.1. ENGINE
1. Service engine according to engine owner's
manual.
3.4.2. FUEL FILTER
1. Service fuel filter as instructed below, on COLD
ENGINE ONLY!
NOTE: It may be necessary to drain the fuel tank before
removing fuel filter to prevent spillage of gasoline.
2. Locate fuel filter. Remove hose clamps and fuel
hoses from both sides of fuel filter.
3. Install new fuel filter part number 1-4359. See
Figure 3.11.
FIGURE 3.11
4. Fill fuel tank with fresh gasoline. Refer to engine
owner's manual for fuel specifications.
3.4.3. SPARK PLUG
Remove and replace engine spark plug. Refer to
engine owner's manual for correct replacement plug
and gap specifications.
3.4.4. HYDROSTATIC TRANSMISSION OIL
The hydrostatic transmission does not require
maintenance. If any problems arise return
immediately to a Snapper dealer.
NEW FUEL FILTER
PART NUMBER 1-4359