Filter
Top Products
11
Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any adjustments, maintenance,
service, or repairs with engine running. Stop auger.
Stop engine. Remove key. Remove spark plug wire
and secure wire away from spark plug.
4.1 AUGER BELT ADJUSTMENT/REPLACEMENT
When operating machine release the auger clutch
control. The auger should come to a complete stop in
5 seconds. If the auger does not come to a complete
stop in the required time, check and adjust belt
tension. Inspect belt frequently for signs of excessive
wear. Observe drive belt for slippage due to wear
when operating machine. If slippage does occur
adjust as follows.
4.1.1. AUGER BELT CABLE ADJUSTMENT
1. Measure control cable extension from a relaxed
position to full extended position. Move control lever
against handle. Measure the overall length of the
spring. The length of the cable spring should
increase by 1/2” to 3/4” when the clutch control is
depressed. See Figure 4.1.
FIGURE 4.1
2. Loosen jam nut at the upper end of cable. Hold
threaded end of cable and then turn cable clockwise
until correct extension is achieved. Retighten jam nut.
IMPORTANT: DO NOT over tighten cable. The control
cable must have slack for the auger brake to function
properly. If the auger control cannot be properly adjusted,
belt adjustment and/or replacement will be required.
Refer to Section “Auger Belt Idler Pulley Adjustment”.
4.1.2. AUGER BELT IDLER PULLEY
ADJUSTMENT
NOTE: To adjust the idler pulley and properly tension
the auger belt, the auger control cable adjustment
must first be loosened as described in the following
step. Cable adjustment must be checked after
completing the idler pulley adjustment.
1. Loosen jam nut at the upper end of cable. Hold
threaded end of cable and then turn metal housing of
cable counter clockwise until threaded portion of cable
is extracted from metal housing. Reinstall 1/2” of the
threaded portion of cable back into metal housing.
Retighten jam nut.
2. Remove belt cover. See Figure 4.2
FIGURE 4.2
(Continued on the Next Page)
UPPER
HANDLE
CABLE SPRING
SHOULD EXTEND
1/2” TO 3/4”
AUGER CLUTCH
CONTROL
RELAXED
CABLE
HOUSING
JAM
NUT
EXTENDED
REMOVE COVER
FOR IDLER PULLEY
ADJUSTMENT