Filter
Top Products
OperaUofl
,WARNING
if you do not understand how a specific control
functions, or have not yet thoroughly read the
FEATURES & CONTROLS section, do so now.
Do NOT attempt to operate the tractor without
first becoming familiar with the location and
function of ALL controls.
STARTING THE ENGINE
1. While sitting in the operator's seat, engage the
parking brake and make sure the PTO switch is
disengaged and the motion control handles are
locked in the NEUTRAL position.
2. NOTE: A warm engine may not require
choking.
Set the engine throttle control to FAST throttle
position. Then fully close the choke by pulling the
knob OUT fully.
3. Insert the key into the ignition switch and turn it to
START.
4. After the engine starts, gradually open the choke
(push knob down fully).
Warm up the engine by running it for at least a minute
before engaging the PTO switch or driving the ride_
5. After warming the engine, ALWAYS operate the
unit at FULL THROTTLE when mowing.
In the event of an emergency the engine can be
stopped by simply turning the ignition switch to
STOP. Use this method only in emergency situations.
For normal engine shut down follow the procedure
given in STOPPING THE RIDER.
STOPPING THE RIDER AND
ENGINE
1. Returning the ground speed control levers to the
middle position will stop tractor movement. Pivot
the levers outward and lock them in NEUTRAL.
2. Disengage the PTO by pushing down on the PTO
switch.
3. Engage the parking brake by pulling the handle up
until it locks into position.
4. Move the throttle control to mid-throttle position
and turn the ignition key to OFE Remove the key.
®
DO NOTTOW RIDER
Towing the unit will cause hydraulic pump
and wheel motor damage. Do not use
another vehicle to push or pull this unit.
PUSHING THE RIDER BY HAND
1. Disengage the PTO, engage the parking brake,
turn the ignition OFF, and remove the key.
2. Lift the seat plate to gain access to the hydraulic
pumps.
3. To disengage the pumps (free-wheel position), turn
the hydraulic release valves (A, Figure 2) located
on the pumps COUNTER-CLOCKWISE a
maximum of 2 full turns.
4. Disengage the parking brake.
The tractor can now be pushed by hand.
5. After moving the tractor, re-engage the pumps
(drive position) by turning the release valves
CLOCKWISE and tighten to 80-120 in. Ibs. of
torque.
Figure 2. Transmission Release Valves
A. Hydraulic Release Valve (On Each Pump)
15