Filter
Top Products
5
Section 1 – FAMILIARIZATION
FIGURE 1.1
1.1 INTRODUCTION
This manual has been prepared for the operator’s of the
SNAPPER OUT FRONT Z-RIDER. Its purpose, aside
from recommending standard operating procedures and
routine service requirements, is to promote SAFETY
through the use of accepted operating practices. Read,
Understand and Follow the IMPORTANT SAFETY
INSTRUCTIONS on Page 2 and 3 of this manual and All
SAFETY messages on the OUT FRONT Z-RIDER and its
attachments before operating. SNAPPER recommends
returning the OUT FRONT Z-RIDER to an authorized
SNAPPER dealer annually for inspection and addition of
any new devices which might upgrade the safety of the
mower.
1.2 NOMENCLATURE
The nomenclature information above, Figure 1.1,
shows the essential parts of the SNAPPER OUT
FRONT Z-RIDER. It is recommended that all operator’s
of this equipment become thoroughly familiar with the
controls, components, and operation of this machine
before operating. Specific details involving the engine
are found in the separate engine owner’s manual.
Study these manuals before operating and keep both
handy for future reference. For the nearest SNAPPER
dealer in your area, check the yellow pages under the
heading LAWN MOWERS. For engine parts and
service, look for the engine manufacturer’s dealers
under the heading, ENGINES - gasoline.
OPERATOR’S SEAT
FUEL TANK
CONTROL PANEL
(SEE INSET)
IGNITION
SWITCH
AMP
METER
BLADE SWITCH
DECK
LIFT
SWITCH
LIGHT
SWITCH
HOUR
METER
CONTROL PANEL
PARKING BRAKE
MOTION
CONTROL
(JOYSTICK)
DISCHARGE
DEFLECTOR
ENGINE SPEED
CONTROL
DECK COVER
DECK HEIGHT OF
CUT DECAL
CASTER
WHEEL
BRACKET