Filter
Top Products
16
Section 3 - MAINTENANCE
3.3.4. TRACTOR LUBRICATION
1. Front Wheel Bearings
Lubricate each front wheel bearing through the
grease fitting on wheel hub. Using general purpose
grease in a grease gun, add grease until grease
purges from bearing. See Figure 3.5.
FIGURE 3.5
2. Axle Spindles
Lubricate each axle spindle with 1 to 3 shots of
general purpose grease. See Figure 3.5.
NOTE: The R.H. spindle fitting faces forward and the
L.H. spindle fitting faces to the rear.
3. Clutch/Brake Pivot
The clutch/brake pivot is located on the L.H.
underside of the tractor and is lubricated with one
shot of general purpose grease. See Figure 3.6.
FIGURE 3.6
4. Steering Sector Gear
Lubricate with a light coat of general purpose grease.
See Figure 3.7.
FIGURE 3.7
5. Steering Shaft
Lubricate steering shaft wear points with a light coat
of 30 wt. Motor oil.
6. Steering Drag Link
Lubricate both ends of steering drag link with a small
amount of 30 wt. motor oil from an oil can. See
Figure 3.8.
FIGURE 3.8
AXLE SPINDLE
LUBRICATION
FITTING
FRONT WHEEL
BEARING LUBRICATION
FITTING
CLUTCH/BRAKE
PIVOT LUBRICATION
FITTING
STEERING
SECTOR
FUEL TANK
SECTOR
GEAR
DRAG LINK
LUBRICATION
POINT