Filter
Top Products
10
Section 3 - ADJUSTMENTS & REPAIR
3.3.2. ADD LUBRICATION TO CHAIN CASE: To
add grease, remove the filler plug located just
forward of the pulley shaft on the right hand side.
See Figure 10. Add Snapper Part No. 2-9577
Benalene 900 grease (4 oz. Bottle) as needed to
bring level up to bottom edge of the check plug
opening. The total capacity of the case is about 48
ounces. DO NOT exceed this amount. Reinstall
check plugs after checking. NOTE: Also available
Snapper Part No. 2-9296 Benalene 900 grease (32
oz. Bottle).
FIGURE 10
3.4 TILLER TINES
Your Snapper Tiller has right hand and left hand tines.
Replace both tines if blades become bent or are badly
worn or otherwise damaged. Use correct Snapper
replacement tines. The tines are secured to the tine shaft
with a shear bolt, Part No. 2-8725 and Lock Nut Part No.
9-0222 on each side. NOTE: Two extra nuts and two
bolts come with tiller. Keep spares on hand in case a bolt
shears off or becomes lost while tilling. See Figure 11.
DO NOT over tighten these shear bolts as this will cause
premature failure. (Recommended torque is 5 to 8 foot
pounds maximum). NOTE: Failure to use the correct
shear bolts could result in serious damage to your Tiller.
Use only the genuine Snapper replacement bolts and
lock nuts specified above. These bolts are designed to
shear at a specific stress to prevent damage. DO NOT
use substitutes!
FIGURE 11
3.5 BELT ADJUSTMENT - REPLACEMENT
STEP 1: BELT TENSION ADJUSTMENT: From the
right side under the fuel tank, measure the length of the
idler pulley spring at the end of the control cable in a
relaxed position. Then move wheel and tine control bail up
to the handle bar and measure the extended length of the
spring. When properly adjusted, the spring will extend 1/4”
to 1/2”. See Figure 12. To adjust, loosen and reposition
the two jam nuts on the threaded end of cable located on
the dash panel. Move jam nuts toward the end of
threaded end of cable for more tension. Move jam nuts in
a direction away from the end of threaded end of cable for
less tension. See Figure 13. After adjustment, retighten
both jam nuts against dash panel.
FIGURE 12
CHAIN
CASE
RIGHT
HAND
WHEEL
MAIN CASE
FILL PLUG
SHEAR BOLT
(TORQUE TO
8 FT. LBS.)
LOCK NUT
TINE
ASSEMBLY
BELT