Filter
Top Products
23
Engine
Perform all maintenance as specified in the Maintenance
Chart in this manual.
Fuel Filter
IMPORTANT: Service the fuel filter on a COLD ENGINE
ONLY!
1. Drain the fuel from the fuel tank.
2. Start the engine and allow it to run until the engine runs
out of fuel.
3. Remove the hose clamps (B, Figure 30) from the fuel
filter (A).
4. Remove the fuel lines from the filter. Discard the filter.
5. Install a new fuel filter.
6. Carefully reinstall the fuel clamps.
7. Check the fuel system for leaks.
In addition to regular maintenance, the following
components of the Rear Engine Rider should be carefully
inspected regularly for wear or damage.
1. All bushings and pivot areas.
2. Check both front wheel king pins.
3. Transmission shift lever and detent.
4. Clutch disc.
5. Clutch yoke.
6. Mower deck linkage and pivot areas.
Replace worn or damaged parts. Use only factory authorized
replacement parts or like parts when making repairs.
Storage (Out of Season)
If desired, the Rear Engine Rider can be stored on the rear
bumper. Perform the following procedures to insure the Rear
Engine Rider will operate properly when taken out of storage.
1. Thoroughly clean the Rear Engine Rider by removing all
grass clippings and debris.
2. Perform maintenance and lubrication as required.
3. Drain the fuel from the fuel tank.
4. Start the engine and allow it to run until the engine runs
out of fuel. This allows the carburetor and fuel system
to remain clean during storage.
5. Remove and store the battery. Refer to the Section
entitled “BATTERY STORAGE”.
6. Carefully stand the Rear Engine Rider on its rear bumper
in the desired location for storage.
WARNING
DO NOT attempt any adjustments, maintenance, service or
repairs with the engine running. STOP engine. STOP blade.
Engage parking brake. Remove key. Remove spark plug
wire from spark plug and secure away from plug. Engine
and components are HOT. Avoid serious burns, allow all
parts to cool before working on machine. Fuel Filler Cap
must be closed securely to prevent fuel spillage.
!
!
Figure 30: Replacing the fuel filter
C
A
B
Maintenance
IMPORTANT
To avoid damaging the emissions system:
• Do not overfill the fuel tank. Stop filling the tank when
fuel collects in the filler neck.
• Empty the fuel tank before standing the machine on its
rear bumper.
Not for
Reproduction