Filter
Top Products
11
Operation
Installing the Recycling Plug
(Optional Accessory on Some Models)
1. Install the recycling plug (A, Figure 11) if recycling is
desired after the bag adapter is installed. Install the
recycling plug completely and securely into the bag
adapter (B).
2. Install the grass bag as a safeguard.
3. Refer to the Section entitled “Recycling Operation”.
Installing the Grass Bag
(Door Type Bag)
1. Install the grass bag adapter. Refer to the Section
entitled “Installing the Grass Bag Adapter”.
2. Install the grass bag by sliding the connector (A, Figure
12) over the adapter flange.
3. Attach the grass bag hooks (B) over the middle handle
cross bar.
WARNING
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
!
!
WARNING
DO NOT operate without entire Grass Catcher or guard
in place. Grass Catcher components are subject to
deterioration during normal use. Inspect frequently and
replace worn or damaged components immediately.
!
!
WARNING
Grass Catcher bags used on SNAPPER products are made
of woven fabric, and are subject to deterioration and wear
during normal usage. Check condition of bag before each
use. Immediately replace worn or damaged catcher bags
with only bags recommended by SNAPPER. The grass
catcher is optional equipment on some models.
!
!
Figure 12: Installing the grass bag
B
A
Operation (Continued)
Figure 11: Installing the recycling plug
B
A
Not for
Reproduction