Filter
Top Products
Axion / 150Z Series
8/2008 11 TP 300-5412---ZT-SN
5/16-18
x 1-3/4
5/16-18
15-17 ft. lbs.
20-23 N.m.
Setting Up the Ground
Speed Control Levers
1. Loosen (do not remove) the hardware securing the
ground speed control levers to the lever bases.
2. Raise the levers, aligning the upper hole in each lever
with the upper slotted hole in the lever base.
3. Install the noted hardware as shown in Figure 7.
Tighten all hardware. Torque to 15-17 ft. lbs. (20-23
N.m.).
Note: Ground speed control levers must be adjusted
prior to use. Refer to the Section ‘Ground Speed
Control Lever Adjustment’ in the Operator’s Manual.
B
A
C
A
B
C
Figure 7. Setting up the ground speed levers