Filter
Top Products
2
FIGURE 3
STEP 9: Check adjustment of wheel drive control
spring. With the wheel drive control lever in the
"OFF/Released” position measure the length of the
wheel drive control spring. Move the wheel drive control
lever to the "ON" position and measure spring length.
The spring should extend 1/2" to 3/4" from its original
length.
WARNING
Engine must be OFF for this adjustment.
If adjustment is needed, unhook wheel drive control
spring from cable and rotate spring until proper spring
extension is achieved. See Figure 4. Set cutting height
as desired.
FIGURE 4
STEP 10: Fill engine to full mark on dipstick. See
Engine Manual for proper oil specifications.
STEP 11: Set-Up is now complete.
Blade Control
Spring
1/4” To 3/8” Extended
Wheel Drive
Control
Cable
There should be some
slack in cable.
NOTE: Gap between
cable eyelet and spring
hook.