Filter
Top Products
11
Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE
2.4.4. PARK BRAKE
1. Engage park brake by pushing clutch/brake pedal
“DOWN” and moving the park brake lever to the “ON”
position. While holding the park brake lever “ON”,
release clutch/brake pedal to set park brake.
See Figure 2.16.
FIGURE 2.16
2. Release park brake by pushing down on the
clutch/brake pedal to release park brake lever. See
Figure 2.17.
FIGURE 2.17
2.5. CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any one of six
positions using deck lift lever. When in desired
height of cut, release latch, then try to move deck
lift lever to ensure lift lever latch is fully engaged.
See Figure 2.18.
FIGURE 2.18
WARNING
DO NOT park the machine on slopes.
TO APPLY BRAKES, PUSH
CLUTCH/BRAKE PEDAL
ALL THE WAY DOWN.
MOVE PARK
BRAKE LEVER TO
“ON”
TO APPLY BRAKES,
PUSH CLUTCH/BRAKE
PEDAL ALL THE WAY
DOWN.
PARK BRAKE LEVER
SHOWN IN “OFF”
POSITION
DECK LIFT
LEVER
LIFT LEVER LATCH