Filter
Top Products
6
Snapper 2300 PSI Pressure Washer
4. Insert the other “L” hook through the hole just above
the billboard on the right side of the handle (viewing
from rear of unit). Hold the hook in place with a pliers
and attach the locknut with a 7/16” wrench (Figure 3).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended oil
to engine.
NOTE: Check Oil Often During Engine Break–in.
Add Fuel
WARNING! NEVER fill fuel tank indoors. NEVER
fill fuel tank when engine is running or hot.Allow unit
to cool for two minutes before refueling. DO NOT
light a cigarette or smoke when filling the fuel tank.
WARNING! DO NOT overfill the fuel tank.
Always allow room for fuel expansion.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended
fuel to engine.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
• Uncoil the high pressure hose and attach one end of the
hose to the base of the spray gun (Figure 3).Tighten by
hand.
Connect high
pressure hose here
Figure 3 — Connect High Pressure Hose to Spray Gun
Hose Hook
Spray Gun
Hook
Figure 3 — Attach “L” Hooks to Handle