Filter
Top Products
10
Section 2 - OPERATING INSTRUCTIONS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
2.9 INSTALLATION of GRASS BAG
(Continued From Previous Page)
Attach grass bag hooks over middle handle cross bar.
See Figure 2.14.
FIGURE 2.14
2.10 INSTALLATION of GRASS CATCHER
(Slide Closure Type)
Position grass bag between handles. See Figure
2.15. Install grass catcher by sliding connector over
flange of adapter. Attach grass bag hooks over
middle handle cross bar. See Figure 2.15.
FIGURE 2.15
FIGURE 2.16
2.11 REMOVING and DUMPING GRASS CATCHER
1. Grasp bag connector and bag handle as shown.
See Figure 2.16.
2. First, lift up on bag handle, removing it from the
mower handle. Then lift up on bag connector
removing it from the adapter flange.
3. Dump bag by pulling bag slider off of Z-Fold at
rear of bag, opening bag.
4. To close bag, fold rear of bag into Z-shape,
keeping edges aligned. Note: an illustration of
folding the Z-shape is attached to the bag.
5. Grasp the edge of the Z-fold, and while holding
the slider, pull the Z-fold fully into the slider. See
Figure 2.17.
FIGURE 2.17
ATTACH BAG HOOKS
OVER MIDDLE HANDLE
CROSS BAR
MIDDLE
HANDLE
CROSS
BAR
LOWER HANDLES
HANDLE
BAG CONNECTOR
ADAPTER
FLANGE
GRASP SLIDER.
PULL Z-FOLD INTO
PULL
SLIDE CONNECTOR
OVER END OF
ADAPTER FLANGE
HOOK BAG HANDLE
OVER LOWER
HANDLES