Filter
Top Products
9
2. Attach the auger drive cable (C, Figure 3) to the
auger drive lever (A) using the Z-hook (B).
3. Remove the t-knob (B, Figure 4) and bolt on the
upper chute.
4. Rotate the upper chute (A) to the operating position
(past the lower chute stop)
5. Install the bolt and tighten the t-knob (B).
Engine
1. The snow thrower was shipped with a container of
5W30engine oil. Before operating, add this oil to the
engine.
2. Remove the oil fill cap/dipstick access panel (A,
Figure 5).
3. Remove the oil fill cap/dipstick (B). Fill to the FULL
mark on the oil fill cap/dipstick. Periodically check the
oil level. DO NOT OVER FILL.
4. If not installed, install the fuel cap (C) onto the fuel
tank.
Figure 3. Z-Hook Installation
A. Auger Drive Lever
B. Z-Hook
C. Auger Drive Cable
A
B
Assembling the Snowthrower
C
Figure 4. Upper Chute Installation
A. Upper Chute
B. T-Knob
C. Lower Chute
A
B
C
Figure 5. Add Engine Oil
A. Access Panel
B. Oil Fill Cap/Dipstick
C. Fuel Cap
A
C
B