Filter
Top Products
2
Installation Instructions 54” Mower Mulch Kit
Drill 11/32" Hole Here
Drill 11/32" Hole Here
1-1/4"
25/32"
2-1/2"
3-11/32"
Deck Viewed from Above
Note: Dashed
holes in early
models only.
A
A
A
A
Figure 3. Drill Ramp Mounting Holes
A. Cover Bolt Holes
5. Remove capscrews securing the belt covers and
remove the belt covers.
6. Using a grease pencil and straight edge, draw a line
between the belt cover bolt holes (A, Figure 3).
7. Use a ruler and right-angle square to locate the ramp
mounting holes as shown in Figure 3. Center punch
and drill two 11/32” holes in the locations shown.
The ramps themselves will be used to locate the
remaining holes.