Filter
Top Products
Tire Pressure
Front 25 psi (1,72 bar)
Rear 15 psi (1,03 bar)
Figure 11. Checking Tire Pressure
CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that
these pressures may differ slightly from the “Max
Inflation” stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve cut
quality, and extend tire life.
CHECKING / ADDING FUEL
To add fuel:
1. Remove the fuel cap (see Figure 1).
2. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.
FUEL FILTER
The fuel filter is located in the fuel line between fuel tank
and carburetor, near the fuel pump. If filter is dirty or
clogged, replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using a pliers, open and slide hose clamps from fuel
filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.
CHANGE OIL & FILTER
1. Warm engine by running for a few minutes. (Refer to
the engine operator’s manual for oil & filter
replacement instructions.)
2. Remove the oil drain hose (A, Figure 12) from the
cable clamp (C) on the right-hand side of the frame
and route the hose towards the rear of the machine
as shown in Figure 12.
3. Place a small pan under the oil drain hose to catch
the oil. Using the appropriate tools, remove the cap
(B, Figure 12) from the oil drain hose (A) and drain
the engine oil.
4. After draining, replace the cap and wipe up any
spilled oil. Reinstall the oil drain hose into the cable
clamp to retain the hose during normal operation.
5. Place an absorbent shop cloth under the engine oil
filter. Remove the engine oil filter and replace with a
new one.
6. Remove the shop cloth and wipe up any spilled oil.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the area.
Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage
could result.
Regular Maintenance
Figure 12. Engine Oil Drain
A. Oil Drain Hose
B. Cap
C. Cable Clamp
C
B
ENGINE MAINTENANCE
Refer to engine owner’s manual for all engine
maintenance procedures and recommendations.
19
A