Simplicity 85268E Snow Blower User Manual


 
Adjustments & Service
29
Figure 29. Frame and Axle Housing
A. Upper Capscrews
B. Lower Capscrews
C. Auger Housing
D. Frame
B
Figure 27. Spout Rotator Rod
A. Special Nut
B. Cover
C. Hair Pin
D. Spout Rotator Rod
A
B
C
D
A
B
D
A
D
C
Figure 28. Install Spout Rotator Rod
A. Hex Dash Opening
B. Spout Rotator Rod
15. Index or point the spout rotator to the center of the
machine so the rotator control is in the center of the
dash panel.
16. Slide spout rotator rod (B, Figure 28) into hex dash
opening (A).
17. Insert hair pin (C, Figure 27) into spout rotator rod
(D).
18. Install cover (B) and secure with special nut (A).
19. Install the auger drive belt (D, Figure 26) onto the
impeller pulley (H).
20. Slip the auger drive belt (D) under the idler pulley (K).
21. Adjust the auger drive belt. See “How To Adjust The
Auger Drive Belt” in the Service section.
22. Adjust the belt guide. See “How To Adjust The Belt
Guide” in the Service section.
23. Install the belt cover (A, Figure 21). Tighten screws
(B).
24. Check the adjustment of the cables. See “How To
Check And Adjust The Cables” in the Adjustment
section.
25. Install the bottom panel (B, Figure 25).
26. Tighten the capscrews (A) on each side of the bottom
panel (B).
27. Connect the spark plug wire.
A
B
A
B