Filter
Top Products
Operation
WARNING
AVOID SERIOUS INJURY OR DEATH FROM ROLL
OVER:
Keep roll bar in the raised position and use seat
belt.
THERE IS NO ROLL OVER PROTECTION WHEN
THE ROLL BAR IS DOWN
Lower the roll bar only when necessary and
NEVER remove it.
Do NOT use seat belt when the roll bar is down.
Raise the roll bar as soon as clearance permits.
Do NOT jump off if mower tips.
Check for overhead clearances before driving
under any objects. Do not allow roll bar to
contact low overhanging obstacles such as tree
branches and guide wires.
Figure 9. Raise & Lower the Roll Bar
A. Hair Pin Clip
B. Retainer Pin
C. Roll Bar
D. Rubber Stop
16
RAISE & LOWER THE ROLL BAR
To lower the roll bar:
1. Pull the hair pin clips (A, Figure 9) out of the retainer
pins (B).
2. Push or pull the top of the roll bar (C) forward
against the rubber stops (D) and remove the retainer
pins (B).
3. Lower the roll bar and reinstall the retainer pins and
hair pin clips to secure the roll bar in the down
position (see insert, Figure 10).
To raise the roll bar:
1. Pull the hair pin clips (A) out of the retainer pins (B)
and remove the retainer pins.
2. Raise the roll bar (C) until the rubber stops (D)
contact the upright tubes.
3. Push or pull the top of the roll bar forward against
the rubber stops and reinstall the retainer pins and
hair pin clips to secure the roll bar in the raised
position.
C
B
A
D
D
C