Filter
Top Products
3
Landlord / 1700 / 2700 Update Kit Installation Instructions
Route through
Plastic Sight
Gauge in Seat
Deck
Figure 3. Gas Tank Replacement
A. Top Seat Deck Capscrew
B. Seat Deck
C. Foot Rest Capscrew
D. Plastic Sight Gauge
E. Filter Plate Hardware
F. Seat Deck Brackets
G. Top Sight Tube Fitting
H. Clear Sight Tube
I. Small Hose Clamps
J. Bottom Sight Tube Fitting
K. Frame
L. Fuel Line Fitting
M. Fuel Tank
N. Fuel Cap
O. Seat Deck Bracket Hardware
P. Filter Plate
A
B
C
D
A
B
F
E
E
N
M
L
K
H
G
J
I
O
P
Install Seat Deck
1. Set the seat deck (B, Figure 3) on the seat deck
brackets (F).
2. Tip the seat deck (B) forward to access the sight tube
(H).
3. Route the seat switch wire harness through the hole
in the top of the seat deck.
4. Lubricate the sight tube (H) with white lithium grease.
5. Insert the tube (H) through the sight gauge (D) from
the top while tipping the seat deck down. All slack
tubing must be removed from above the sight gauge
or the clear tube (H) will kink.. Before securing the
seat deck, check that the tube is not kinked at the top
fitting (G).
6. Using an allen wrench, insert the small orifice fitting
(B, Figure 2) apx. 1/2”-3/4” into the bottom of the
clear tube (A).
7. Connect the clear tube (H, Figure 3) to the bottom
fuel tank fitting (J). Secure using the hose clamp pro-
vided.
8. Secure the seat deck (B) to the seat deck brackets
(F) and frame (K) using the original hardware (A &
C).
Figure 2. Install Orifice
A. Clear Tube
B. Orifice