Filter
Top Products
Regular Maintenance
access Engine
ACCESSING THE ENGINE
To gain access to the angina, unhook the rubber straps
(Figure 18) and tip the hood forward.
NOTE: For engine service item locations see Figure
20 for models with Briggs
&
Stratton engines and
Figure 19 for models with Kohler engines
FUEL FILTER REPLACEMENT
The fuel filter (E, Figures 19 and 20) is located in the fuel
line between the fuel tank and the carburetor.
If filter is dirty or clogged, replace as follows:
1. Disconnect the negative battery cable
2. Place a container below the filter to catch spilled fuel.
3. Using a pliers, open and slide hose clamps from fuel
filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.
OIL
&
FILTER
C~HANGE
Refer to engine manual for specific oil and filter recom-
mendations and oil draining procedures.
CHECK
/
CHANGE AIR
FliTER
Refer to the engine manual for specific air filter service
procedures.
INSPECT & REPLACE SPARK PLUGS
Refer to the engine manual for specific spark plug
replacement procedures.
Figure 19. Engine Compartment
-
16 HP Kohler Single Cylinder Engine
A. Battery D Oil Fill/Dipstick
8. Oil Filter
E. Fuel Filter (Not Shown
C. Air Filter
F. Throttle/Choke Cable
Figure 20. Engine Compartment’
-
14 HP, 16 HP,
&
18 HP Briggs &Stratton
Twin Cylinder Engine
A. Battery
E. Fuel Filter
B. Oil Filter F. Throttle Cable
C. Air Filter
G. Choke Cable
D Oil Fill/Dipstick
17