Filter
Top Products
Auger and Impeller Group - 24"
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
Apply a bead of gasket eliminator
into rear seal groove and flat surface
just past groove (Ref. 15 & 20) on both
halves. Also, apply to bushing bore surface.
Be careful not to over apply as excess will
cause lip seal to not function properly.
Torque to
9 - 11 ft-lbs.
Torque to
30 - 44 ft-lbs.
Torque (Ref. 2) to
17 - 22 ft-lbs.
Hub of pulley
to face auger.
Locate pulley on worm shaft
(Ref. 10) so the belt is 1.94"
from rear of impeller housing.
Apply grease until it appears
at ends of auger assembly.
Auger stamped "L".
Place 1 or 2 washers
per side as required.
Auger stamped "R".
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
2
3
3
17
13
29
28
24
25
23
26
27
30
986355
The above parts group applies to the following Mfg. Nos.:
2003
16
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694433 - 860E
1694434 - 860M
TP 400-3889-00-LW-S