Filter
Top Products
Page 13
STARTING AND STOPPING THE
ENGINE
To Start Engine:
1. Drive control levers should be released to neutral
position.
2. Turn fuel shut-off valve (if equipped) 1/4 turn to
open
.
3. Push choke lever to
choke
position.
4. Move throttle control lever to
fast
position.
5. Push rocker switch (if equipped) to
on
.
6. Pull start engine. Stand to the right of tiller engine,
grasp rope handle and pull rope out, slowly, until it
pulls slightly harder. Let rope rewind slowly. Then
pull rope with a rapid full arm stroke. Let rope return
to starter slowly. Let engine warm for a few minutes
before beginning to operate.
7. When engine starts, operate in
fast
position.
8. Move choke lever toward
run
position.
NOTE: If engine does not start after 3 pulls, check
troubleshooting guide for suggestions.
To Stop Engine:
1. Move throttle control to
slow
position. Then move to
stop
position.
2. Push rocker switch (if equipped) to
off
.
3. Close fuel shut-off valve (if equipped).
Refer to your engine manual for further information.
Operation
CAUTION
Always keep hands and feet clear of rotating machine
parts.
CAUTION
Temperature of muffler and near by areas may exceed
150° F. Avoid these areas.
CAUTION
Do not move choke lever to CHOKE to stop engine.
Backfire or engine damage may occur.
To stop the engine at any time, move throttle control
to the off position. To stop wheels and tines at any
time, release drive control levers to neutral position.