Filter
Top Products
19
Service
Figure 22. Auger Drive Clutch Rod Adjustment
Auger Drive
Clutch Rod
Auger Drive
Clutch Rod Spring
Adjustment
Hex Nuts
AUGER DRIVE CLUTCH ROD
ADJUSTMENT
The auger drive clutch rod should be adjusted so that
there is no slack in the rod when moved slightly from
side to side. To adjust tension on the rod:
1. Loosen adjustment hex nuts (Figure 22).
2. Tighten top hex nut while holding rod. Tighten just
until slack in rod is removed. Be careful not to move
idler rod lever when adjusting clutch rod tension.
3. Tighten lower hex nut securely.
4. Start unit and check auger. Auger must not be
engaged unless Auger Control is depressed.
5. With engine running, fully depress Auger Control, the
auger should engage and run normally.
6. Release Auger Control. Auger must stop within 5
seconds.
7. If auger does not operate properly, stop engine and
recheck clutch rod adjustments.
8. If clutch rod is properly adjusted, auger drive belt ten-
sion may require adjustment. See "Adjusting Auger
Drive Belt" on next page.
Figure 23. Drive Belt Paths
DRIVE BELT ADJUSTMENT
The snowthrower is equipped with two drive belts locat-
ed just in front of the engine under the belt cover. Figure
23 shows both belts and idler pulleys. The belt nearest
the engine is the unit traction drive (wheels) belt. The
belt farthest from the engine is the auger/ impeller drive
belt.
The traction drive belt has constant tension provided by
a spring-loaded idler pulley arm, and is non-adjustable.
This belt rotates whenever the engine is running, and
provides power to the traction drive disc, which also
rotates constantly while the engine is running.
The auger drive belt tension may be adjusted by moving
the auger drive idler pulley. See "Adjusting Auger Drive
Belt’ on next page.
Idler Rod
Right Handle
Engine Pulley
Idler Pulley
Auger Pulley
Engine Pulley
Idler Pulley
Traction
Drive Pulley
FRONT
(Auger)
DRIVE
BELT
AUGER
BELT
01
WARNING
Do not over-tighten, as this may lift the idler rod
lever and cause auger drive to be engaged
without depressing the Auger Control.