Filter
Top Products
Figure 8. Quick Connectors
A. Hoses
B. Quick Connector
C. Connector Covers
15
Operating the Tractor
A
B
C
Connecting Hydraulic Hoses
The female quick connectors (B, Figure 8) require a 1/4”
male nose piece fitting (part number 173359).
Connect the hoses from the attachment hydraulic cylin-
ders (A, Figure 8) to the quick connectors (B) located
under the left foot rest. Refer to the flow diagrams in
Figure 6 to determine the correct quick connector to con-
nect to. Be sure to install the quick connector covers
(see Figure 9) after disconnecting hydraulic hoses.
Test Run Attachment & Check Oil
1. Start the engine.
2. Test all controls for proper function.
3. Check all fittings, connections, and hoses for leaks.
4. Run the tractor for at least 10 minutes. Actuate the
attachment hydraulic cylinders 10 times to bleed air
out of the hydraulic system.
5. Check the oil level. Observe the oil level in the plas-
tic tube (A, Figure 10) at the rear of the unit.
There should be 1” to 1-1/2” of oil in the tube. If there
is no oil in the tube add Type-F automatic transmis-
sion oil a few ounces at a time. The transmission fill
tube is located under the seat (see Figure 11).
Figure 10. Transmission Fluid Check
A. Hydraulic Tube
B. Drain Plug
Figure 11. Transmission Oil Fill
Transmission
Oil Fill
Bumper Removed For Clarity
A
B
Figure 9. Install Quick Connector Covers