Simplicity 1280E Snow Blower User Manual


 
Auger and Impeller Group
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
End of hub to be flush
with end of rolled down
shaft (Ref. 9).
Torque to 30 -34 ft-lbs.
40 - 46 Nm.
Impeller to be positioned
against bearing before
tightening set screw.
Marked side of worm
gear must contact against
left thrust washer to assure
proper gear mesh.
Auger assembly
stamped "R".
Auger assembly
stamped "L".
Torque to
18-21 ft-lbs.
24 - 28 Nm.
Apply grease until
it appears at ends
of auger assembly
(2 places).
Torque to 9 - 11 ft-lbs.
12- 15 Nm.
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
17
18
19
20
21
22
23
24
25
28
27
2
10
10
6
26
14
18
11
2929
985466
The above parts group applies to the following Mfg. Nos.:
2005
20
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694589 - 9560E
1694590 - 1060E
1694591 - 1170E
1694592 - 1280E
1694593 - 1390E
1694597 - 9560M
1694598 - 1060M
1694599 - 1170M
1694600 - 1280M
1694601 - 1390M
TP 400-4155-01-LW-S