Filter
Top Products
9
Choke closed
Throttle
interlock
Fast Idle
button
START
On/Off Switch
Throttle
trigger
Make sure the cutters are
clear of obstructions!
.Pull recoil
starter handle
upward
Hold the unit
rmly...
Slide the ignition switch to the ON postion
Start the trimmer by pulling the starting
handle rapidly outward
Set the choke lever to the CLOSED
position if engine is cold
Return Tube
Primer bulb
Return Tube
Press the primer bulb
Slide the ignition switch to the “ON” position.1.
Set the throttle lever to the “fast idle”:2.
Depress and hold the throttle lock, then squeeze the throttle trigger toward a.
the handgrip on the shaft tube.
Depress and hold the fast idle button.b.
While depressing the fast idle button, release the throttle trigger.c.
Press the primer bulb until fuel can be seen owing in the transparent 3.
return tube.
Set the choke lever to the CLOSED position if engine is cold.4.
Place the unit on the ground. Grip the engine cover with your left hand and the 5.
starter handle with your right hand (shown).
IMPORTANT!
The primer system only pushes fuel through the carburetor. Repeatedly pressing
the primer bulb will not ood the engine with fuel.
IMPORTANT!
If the engine fails to start after several attempts with the choke in the closed
position, the engine may be ooded with fuel. Refer to the “Starting a Flooded
Engine” section of this manual.
Pull the starter handle slowly toward you until you feel the starter mechanism 6.
engage.
Start the trimmer by pulling the starting handle rapidly outward.7.
CAUTION!
The recoil starter can be easily damaged by abuse! Never pull the starter cord
to its full length.
NOTE:
The blade cover is used for transportation and storage. Remove blade
cover before using the unit.