Filter
Top Products
7
NOTE
The plastic shield is for use with the Nylon Line Head only. Install Metal
Shield when using plastic or metal blades.
Remove plastic threaded shaft sleeve and adapter plate (C) from PTO 1.
shaft (A).
Place the shield on the bottom of the bearing housing ange.2.
Place shield plate (B) on shield, align holes. Install three (3) screws from 3.
bottom through plate and shield into gear case.
Assemble adapter plate (C) onto PTO shaft.4.
A
A
C
Install trimmer head
IMPORTANT
Semi-automatic nylon line heads must be used only with plastic debris shield
with cut-off knife. Using nylon line heads with metal debris shield can result
in trimmer damage, caused by operation with excessive line length.
D
To advance trimmer line
Tip:
To advance trimmer line, tap trimmer head against the ground while the head
is turning at normal operating speed.
Nylon line replacement
See Maintenance Section for Loading Trimmer Line.
Remove nylon line head
NOTE
Do not disassemble nylon line head.
Align locking hole in upper plate with notch in edge of gear housing and 1.
insert head locking tool (D).
Remove line head (E) by turning it clockwise until head is completely off 2.
of shaft.
Remove locking tool (D).3.
C
B
D
E
Cutting attachment shield
CAUTION
Wear Gloves or personal injury may result:
• Cutoff knife is sharp.
• Gearcase and surrounding area may be hot.
WARNING!
A standard grass trimmer with a loop handle should NEVER be operated with blade-type attachments. For
blade use, the trimmer must be tted with a bicycle-type handlebar or a barrier bar that is located in front of the opera-
tor to reduce the risk of the operator from coming in contact with the cutting attachment (per ANSI B175.3). When
using a blade, the unit must also be equipped with a harness or strap.
NOTE
Use the 4 mm hexagonal wrench as a gear housing locking tool.
Be sure adapter plate (C) remains on PTO shaft (A). 1.
Align locking hole in upper plate with notch in edge of gear housing and 2.
insert head locking tool (D).
Thread line head (E) onto shaft by turning it 3. counter-clockwise until head
is tight against adapter plate (C).
Remove locking tool (D).4.