Filter
Top Products
Comfortable
back pads
B
B
A
A
A
Figure 20
To tighten straps…
To loosen straps…
Pull strap
loops
down.
Quick-adjust
buckle
Pull the quick-adjust
buckles up…
…and pull the
straps down.
12
Adjusting The Harness
The Shindaiwa blower features an
advanced harness system that helps
ensure maximum operator comfort and
ease of operation.
The shoulder harness is filled with soft
■
padding for reduced operator fatigue.
The simplified adjustment system
■
makes it easy to match the harness to
every body size and type.
Using The Blower
Operating Tips
In the hands of an experienced operator,
the blower can efficiently move a wide
variety of debris ranging from grass clip
-
pings to gravel. As a general rule, operate
your blower at the lowest throttle setting
required to get the job done:
Use full throttle when moving heavy
■
loads such as dirt or snow.
Use low throttle settings when clear
-
Use low throttle settings when clear-Use low throttle settings when clear
■
ing lightweight materials from around
lawns or shrubbery.
Use medium to higher throttle settings
■
to move grass or leaves from parking
lots or walkways.
IMPORTANT!
Blower noise increases at higher throttle
settings! Always use the lowest throttle set
-
settings! Always use the lowest throttle set-settings! Always use the lowest throttle set
ting required to get the job done!
This engine is equipped with a heat sensor
in order to prevent overheating. If engine
overheating occurs, the engine speed will
be reduced to 5,000 min
-1
(RPM). If the
engine speed will not rise above 5,000 min
-1
(RPM), please cool the engine as follows .
CAUTION!
If the engine speed is automatically
reduced again after cooling the
engine, please consult with an
authorized servicing dealer.
Heat sensor
Stop the engine.
■
Remove any leaves and debris blocking
■
intake cover.
Keep the engine speed at idle for 1
■
minute
.
Quick- disconnect
spring hook
Pull on the loops to quickly
tighten the harness straps.
A = Adjust height
B = Adjust angle