Filter
Top Products
7
Mark
“THIS SIDE UP”
must face up
Assembling the Blower
Place the blower upright on the ground or on a sturdy work surface.
1. Grasp the blower tube as shown, and push the tube over the blower dis-
charge port and locking pins.
2. Lock the blower tube to the blower discharge port by rotating the tube as
shown.
Blower
Tube
Locking Pin
Push the blower tube
over the discharge port
and locking pin
Rotate clockwise to lock
Nozzle
Locking Pin
Blower Tube
Push the nozzle
over the blower
tube and locking
pin
Rotate clockwise to lock
1
3
2
4
Danger from
rotating impeller!
Stop the engine before installing or removing the blower tubes!
Never perform any maintenance or assembly procedures on this unit
while the engine is running!
WARNING!
IMPORTANT!
Blower tube installation affects both blower balance and performance!
The tube and nozzle are correctly installed when the mark “THIS SIDE
UP” is visible to the operator during normal operation.
3. Grasp the nozzle with the mark “THIS SIDE UP” positioned as shown,
and then push the nozzle over the straight tube and locking pins.
4. Lock the nozzle to the straight tube by rotating the nozzle as shown.