Filter
Top Products
12
Clean around
spark plug
Lubricate
cutters
Check cutters and
guide bar for damage
and that bolts
are tight
Inspect/clean
air lter
element
Inspect front and rear handles for
damaged or loose attachments
Inspect
cooling ns,
and clean as
required
Clean de-
bris from
tank and
mufer
Daily Maintenance/Inspection
Figure 12
Maintenance and Adjustments
IMPORTANT!
Maintenance, replacement or repair of emission control devices and systems may be performed by any repair establish-
ment or individual; however, warranty repairs must be performed by a dealer or service center authorized by ECHO, Inc. .
The use of parts that are not equivalent in performance and durability to authorized parts may impair the effectiveness of the
emission control system and may have a bearing on the outcome of a warranty claim.
WARNING!
Accidental start-ups can cause
severe injury! Before performing any
maintenance on this equipment, stop
the engine and disconnect the spark
plug!
Remove all grass clippings and dirt from the hedge trimmer.1.
Remove any compacted debris from around the fuel tank and/or mufer. ■
■ Inspect the engine cooling ns for clogging, and clean as necessary.
Clean under the cylinder cover and around the spark plug. Inspect the air lter
■
element for clogging, clean as necessary.
Check for loose, damaged, or missing components, and repair as necessary.2.
Lubricate the cutters with oil before use, and after refueling.3.
Check the cutters for damage and make sure all bolts are tight.4.
WARNING!
To reduce re hazard, keep the engine and mufer free of debris, leaves, or
excessive grease.
Keep cooling
ns clean
Keep cooling air
intake passages
clean
(Fuel tank
removed for
clarity)
Figure 13
Air Filter
The H4 engine that powers your Shindaiwa model is a hybrid 4-stroke engine. As a
hybrid, the engine is lubricated by oil mixed with the gasoline and air from the carbure-
tor that moves through and around the internal parts of the engine in a similar way that
a 2-stroke engine is lubricated. Without the heavy duty 2-stage air filter equipped on all
H4 engines, dust and dirt could also move through the engine, decreasing engine life,
increasing valve wear and the need for more frequent valve adjustments. To keep your
H4 engine strong and reliable, Shindaiwa recommends that you check and service the
air filter as instructed in the 10-Hour Maintenance section that follows.
NOTE:
Using non-standard replacement parts
could invalidate your Shindaiwa warranty.