Shindaiwa 81645 Edger User Manual


 
5
Product Description
Figure 4
Specications
LE242 dry weight
(Including attachments)...........................................12.8 lb./5.8 kg
Engine model...........................................................................S242E
Engine type.......................................................2-cycle with catalyst
Bore x stroke.............................................1.3 x 1.1 in./33 x 28 mm
Displacement.......................................................1.5 cu. in./ 23.9 cc
Maximum power.......................................................1.0 HP/0.8 kW
@ 8000 rpm (min
-1
)
Fuel/oil ratio.............................50:1 with ISO-L-EGD or JASO FC
class 2-cycle mixing oil*
Carburetor type...............................Walbro WYK, diaphragm-type
Fuel tank capacity....................................................22.3 oz./670 ml
Ignition............................................................One-piece electronic,
transistor-controlled
Specifications are subject to change without notice.
Spark plug.....................................................................NGK BPMR6A
Air cleaner type..............................................................Non-reversible
Foam Filter Element
Starting method ............................................................................Recoil
Stopping method ................................................................Slide switch
Transmission type ................................Automatic, centrifugal clutch
w/bevel gear
EPA Emission
Compliance Period**..........................................................Category A
** The EPA emission compliance referred to on the emission compliance label
located on the engine, indicates the number of operating hours for which the
engine has been shown to meet Federal emission requirements. Category
C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours
(Extended).
* meets or exceeds these specifications and is
recommended for all Shindaiwa products.
LE242 LAWN EDGER
Outer Tube
Cutting
Attachment
Grip
Cutting
Attachment Shield
Gear case
Handle
Throttle
Trigger
Throttle
Interlock
Ignition
Switch
Fuel
Tank
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized
modications or alterations to any of
these units or their components.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete unit:
Engine and outer tube assembly with
handle
Gearcase/Debris shield assembly
Kit containing this manual and tool kit
for routine maintenance. Tool kits vary
by model and may include a hex wrench,
a spark plug/screwdriver combination
wrench, and a scraper
.
Carefully inspect all components for damage.