Shindaiwa 41RS Broadcast Spreader User Manual


 
Feed control knob/wire through 4.
the T-handle until spring touches
the round hole. CAUTION: Do Not
Compress Spring At This Time.
Feed wire through the square
handle tube. Be sure wire passes
above the bolts in the handle
brace. Secure T-handle to the tube
with (1) 1/4-20 x 2” hex bolt. (2)
washers, and (1) hex nut in the
bottom hole, and (1) 1/4-20 x 2
1/4” hex bolt, (2) washers, and (1)
hex nut in the top hole as shown.
Remove caution label and push
the thumb release toward the
center and push down knob and
shutoff spring until knob latches.
CAUTION: ONCE KNOB IS LATCHED, DO
NOT MOVE THUMB RELEASE UNTIL YOU
HAVE COMPLETED STEP #5.
Slide wire retaining clip onto 5.
wire as shown. Insert wire
through hole shutoff plate. Slide
wire retaining clip over shutoff
plate and wire until the clip
locks into place.
Install gear cover assembly over gears 6.
and secure with (2) #6-32 screws. The
41RS spreader should now be com-
pletely assembled and ready for use.
Slide handle grips onto handle. Soapy
water will ease installation. (Do not use
petroleum based products.)
Handle Grip
Remove Caution
Label
Control Knob &
Wire Assembly
Spring
Thumb
Release
1/4-20 x
2 1/4” Bolt &
Washer
1/4-20 Hex Nut
& Washer
Wire Clip
Wire
Shutoff Plate
Handle Grip
#6-32 Screw
#6-32 Screw