Filter
Top Products
1) Heater Settings
• Turn the power ON by pressing POWER button and press LOW/HIGH button to
switch the heat setting between HIGH and LOW.
2) Turning the Heater Off
• Press the POWER ON/OFF button to turn the heater off.
• When the unit is turned off, the fan will continue to run for around 15 seconds
to blow out hot air. At the same time display screen will count down from 15
backward to 1. You do not need to hold button down. After the display turns off,
unplug the heater from the electrical outlet.
3) Setting the Temperature
• The default setting temperature is 75°F.
• When the heater is on (HIGH or LOW), press
+/-
button and the “SET” will be lit.
Continue pressing
+/-
button to set the temperature desired between 60°F and
95°F.
• The thermostat is in effect in modes: HIGH and LOW only and will heat to the
desired temperature setting.
• The heater has a built in memory function. When the heater is not unplugged
after last time used, press
+/-
button and display will show the set temperature
from last time. When the heater is unplugged after last time used, the setting
temperature will go back to the default setting temperature. (75°)
Note: If the room temperature is higher than the setting temperature, the unit will
stop heating to save the energy. When the room temperature falls lower than the
setting temperature, the unit will resume heating. The heater will cycle on and off this
way to maintain the set temperature.
8