Filter
Top Products
.................................. M .............
TROU LES OOTING POINTS
PROBLEM
i,,,Ull: ,hi,ill,i ,,, ,;,i n
Does not start
Loss of power
Poor cut - uneven
Excessive vibration
Starter rope hard to pull
...... ,,,,
Loss of drive
Grass catcher not filling
(If so equipped)
Hard to push
CAUSE
1. Dirty air filter,
2, Out of fuel,
3. Stale fuel.
4, Water in fuel,
5. Spark ptug wire is disconnected.
6. Bad spark plug,
7. Loose blade or broken btade adapter,
8. Control bar in released position
9. Control bar defective
t. Rear of lawn mower housing/blade dragging
in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
t. Worn, bent or loose blade,
2, Wheel heights uneven,
3. Low engine speed,
4. Buildup of grass, teaves, and trash under mower,
t. Worn, bent or ioose blade,
2. Bent engine crankshaft.
1. Engine flywheel brake is on when control bar is
released.
2. Bent engine crankshaft
3. Blade adapter broken.
4. Blade dragging in grass.
I. Drive wheels not turning with drive control engaged.
2, Belt not driving.
1. Cutting height too low.
2. Lift on blade worn off.
3, Catcher not venting air.
4. Low engine speed.
t. Grass is too high or wheel height is toe low.
2. Rear of lawn mower housing/blade dragging
in grass.
3, Grass catcher too ful!.
4. Handte height position not right for you.
CORRECTION
,,,,,,,,,,,,, .,,,.,,, , ,,,..........
1, clean/replace air filter.
2. Fill fuel tank.
3. Drain tank and refill with fresh clean fuel
4. Drain fuel tank and carburetorand refill tank with fresh
gasofine,
5. Connect wire to plug.
6. Replace spark plug,
7. Tighten blade bolt or replace blade adapter.
8. Depress control bar to handle.
9. Replace control bar.
1. Set in "Higher Cut" position.
2. Set in "Higher Cut '_position.
3. Clean/replace air filter.
4, Clean underside of mower housing,
5, Check oil level,
6. Cut at slower walking speed,
__,,_,÷ _
t. Replace blade, Tighten blade bolt,
2. Set all wheels at same height,
3. Set engine speed control in HIGH position,
4. Clean underside of mower housing.
1. Replace blade. Tighten blade bolt,
2, Contact Sears Service Department.
1. Depress control bar to upper handle before
pulling starter rope.
2. Contact Sears Service Department,
3. Replace blade adapter.
4, Move lawn mower to cut grass or to hard surface
to start engine.
1. Adjust or reptace drive control cable, if broken,
2. Put belt on pulleys or replace belts if broken.
t. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
4. Set engine speed control in HIGH position.
t, Raise cutting height,
2. Raise rear of lawn mower housing one (1)
setting higher.
3. Empty grass catcher,
4. Adjust handle height to suit,
27