Filter
Top Products
ASSEMBLY
TO ASSEMBLE AND ATTACH GRASS
CATCHER (See Figs. 3A thru 4C )
To assemble tubular frame to grass bag, work sewn
hem of bag out through the front opening of beg to
expose the hem.
Thread tubular frame into hem and gather material at
top of frame as shown.
Push frame inside bag through the opening until only
the ends of frame are exposed out of the front.
NOTE: Do not close the flip lid at this time.
• Assemble lower frame to tubular frame as shown. Be
su re frames are fully seated together as shown in inset.
Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm
water for a few minutes, if bag gets wet, let it dr'/before
using.
Ciose the flip lid. Flip lid must be closed while operating
lawn mower.
Lift the rear door on the rnower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge bracket.
The grass catcher is secured to the lawn mower
housing when the rear door is lowered onto the grass
catcher frame.
=_ CAUTION: Do not run your lawn mower
_ _, w_ deflector or approved
! _ t_Kawnmowerwiththerear
door removed or propped open.
FLiP LID
SEWN i
HEM \
(Pullout
through front
of opening}
TUBULAR
FRAME
(Push inside
bag)
FroG.30
LOWER
/" FRAME
TUBULAR
FRAME
(Frames must /
be fully seated}
FIG. 4A
CATCHER FRAME
\
FIG. 3A
TUBULAR
FRAME
_hreadinto
sewn hem)
FIG. 38
SEWN
HEM
FIG. 4B
DOOR
HINGE
BRACKET
GRASSCATCHERFRAME
FORMED
TABS
7 FIG. 4C