Filter
Top Products
NEGATIVE TERMINAL
CABLES
CHARGED
BATTERY
POSITIVE TERMINAL NEGATIVE TERMINAL
FIG. 31
TO REPLACE HEADLIGHT BULB
• Raise hoo&
• Pull bulb holder out of the hole in the backside of the
grill.
• Repface bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERL.OCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting_
o Check wiring, See electrical wiring diagram in the
Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotive4ype plug-in fuse_ The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
• Raise hood,
• Unsnap headlight wire connector.
• Stand in front of tractor Grasp hood atsides, tilt toward
engine and lift off of tractor,
- To replace, reverse above procedures,
\
\
\
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIGo 32
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cabte_ If adjustment is
necessary, proceed as follows:
• With engine not running move throttle control lever
from slow (,e_) to choke (l\l) position° Slowly move
lever from choke (I\l) to fast (,t_) position
° Checkthat holes"A" in govemorcentrol lever and hole
in governor plate line-up If ho_es "A" are not arigned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely,
GOVERNOR
CONTROL LEVER
GOVERNOR
CONTROLPLATE
HOLES "A"
CLAMP THROTTLE
SCREW CABLE
FIG. 33
25